IBM DR550, Problem Determination And Service Manual

Page: 137 / 258

CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not :
v
Throw or immerse into water
v Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement battery, complete the following steps:
1.
Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the new battery:
a. Hold the battery in a vertical orientation so that the smaller side is facing
the housing.
b. Place the battery into its socket, and press the battery toward the housing
until it snaps into place.
3. Reinstall any adapters that you removed.
4. Reconnect the internal cables that you disconnected.
5.
Make sure that the riser-card assembly is fully seated in the connector on the
system board.
6. Install the cover. See the information about installing the cover in the IBM
System x3650 Type 7979 and 1914 Problem Determination and Service Guide .
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
9. Start the Configuration/Setup Utility program and reset the configuration.
v
Set the system date and time.
v
Set the power-on password.
v
Reconfigure the server.
See “Using the Configuration/Setup Utility program” in the IBM System x3650
Type 7979 and 1914 Problem Determination and Service Guide for details.
Figure 33. Installing the battery
Chapter 12. Field replacement
109