IBM Cloud Object Storage System Slicestor 2212 Series, Service And Maintenance Manual

Page: 159 / 197

Select the destination bank: (A,B): [A] a
TFTP SW load modules
get:
/tftpboot/2212a/LML.ld
from: 10.10.10.99
to:
bank A.
TFTP transfer of /hd0/sys0/LML.ld complete, size=6318 status: OK
TFTP transfer of /hd0/sys0/os.ld complete, size=740936 status: OK
TFTP transfer of /hd0/sys0/snmp.ld complete, size=243980 status: OK
TFTP transfer of /hd0/sys0/sysext.ld complete, size=154409 status: OK
TFTP transfer of /hd0/sys0/initblk.ld complete, size=66022 status: OK
TFTP transfer of /hd0/sys0/tkflash.ld complete, size=131558 status: OK
TFTP transfer of /hd0/sys0/diags.ld complete, size=228496 status: OK
TFTP transfer of /hd0/sys0/router.ld complete, size=5849916 status: OK
TFTP transfer of /hd0/sys0/router.ld complete, size=5849916 status: OK
TFTP transfer of /hd0/sys0/nstation.ld complete, size=632700 status: OK
TFTP transfer of /hd0/sys0/appn.ld complete, size=3004451 status: OK
TFTP transfer of /hd0/sys0/tn3270e.ld complete, size=142874 status: OK
TFTP transfer of /hd0/sys0/encrypt.ld complete, size=1867 status: OK
TFTP transfer of /hd0/sys0/LMX.ld complete, size=1044 status: OK
Operation completed successfully.
Boot config>
7. Type set and press Enter to cause the bank and config file that you just transferred the code load or
configuration data into to become active at the next reload/restart. You will be prompted for the
destination source bank and configuration file. Until you reload the IBM 2212, the state of the bank is
pending.
8. Type reload and press Enter if you transferred new operational code. Type restart if you transferred
a new configuration file.
TFTP File Transfer using the Service Recovery Interface (SVC):
Use the Service
Recovery Interface ( SVC> ) to transfer new software onto the IBM 2212 only if you are replacing the hard
drive or compact flash, or the software on both banks A and B is corrupted and you are replacing it. To
use TFTP at the
SVC>
prompt, follow these steps:
1. Access the
SVC>
prompt. See “Accessing the Service Recovery Prompt (SVC>)” on page E-4.
2. Type interface and press Enter to define the IBM 2212 LAN interface and IP address over which to
transfer the files.
3. At the SVC > prompt, type TFTP and press Enter.
4. Specify whether you want to TFTP a software code load (load) or a configuration file (config). You will
be prompted for the rest of the information. The following example shows a software code load.
Appendix E. Common Tasks
E-21