IBM Cloud Object Storage System Slicestor 2212 Series, Service And Maintenance Manual

Page: 148 / 197

2. Access either the
SVC>
prompt (see “Accessing the Service Recovery Prompt (SVC>)” on
page E-4) or the OPCON ( * ) prompt (see “Accessing the OPCON Command Line
Interface” on page E-2).
| 3. Take one of the following actions, depending on which version of operational code you
| have loaded and prompt you accessed:
|
¹
If you have installed either AIS V3.2, AIS V3.3, or later operational code, from the
SVC>
| prompt, type baudrate and press Enter. You will be prompted for the rest of the
| information.
|
¹
If you have installed AIS V3.2 operational code, from the OPCON (
*
) prompt:
| a. Type talk 6 and press Enter to reach the
Config
>
prompt. If the
Config
>
prompt
| does not appear, press Enter again.
| b. From the
Config>
prompt, type set baudrate and enter the speed.
|
¹
If you have installed AIS V3.3 or later operational code, from the OPCON (
*
) prompt:
| a. Type talk 6 and press Enter to reach the Config
>
prompt. If the Config
>
prompt
| does not appear, press Enter again.
| b. From the Config> prompt, depending on the service port speed you want to
| change, type either set baudrate service1 or set baudrate service2.
| c. Enter the speed.
| Note: You must reconfigure the speed of the ASCII terminal to match the service port
| speed to enter any further commands.
Disabling Dumping
Question How do I disable dumping of memory contents on the IBM 2212?
Answer You can set the IBM 2212 to dump the contents of memory to the hard drive if the IBM 2212
contains one, or a network server attached to the same LAN as the IBM 2212 in the unlikely
event of a complete system failure. If dumping is enabled, using this selection will cause the
IBM 2212
not to dump at the next system failure. The following sections describe the various
methods for disabling dumping on the IBM 2212.
Disable Dumping from OPCON
To disable dumping:
1. Type talk 6 or t 6 at the OPCON (*) prompt and press Enter to reach the Config
>
prompt. If the
Config
>
prompt does not appear, press Enter again.
2. Type disable dump-memory or dis dump at the Config
>
prompt and press Enter.
3. You will be prompted by the following message to confirm:
Disable system memory dumping? [no]: yes
E-10
2212 Service and Maintenance