IBM 8671 - Eserver xSeries 235, Maintenance And Troubleshooting Manual

Page: 129 / 222

Lever closed
Lever
fully
open
6. Pull the microprocessor out of the socket.
Microprocessor
Microprocessor-
release lever
To install a microprocessor, see “Installing an additional microprocessor” on page
82.
Operator information panel
Complete the following steps to remove the operator information panel.
Note:
v
Read “Installation guidelines” on page 45.
v
Read the safety notices at “Safety information” on page 169.
v Read “Handling electrostatic discharge-sensitive devices” on page 172.
1. Turn off the server and any attached devices.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the server cover (see “Removing the left-side cover” on page 55).
4. Remove the front bezel (see “Removing the bezel” on page 56).
5. Disconnect and remove adapters and spacers (see “Working with adapters” on
page 60).
6. Remove the two central fans (see “Replacing a hot-swap fan” on page 94).
7. Remove the plastic baffle.
8. Disconnect the operator information panel cable from the system board.
Chapter 5. Service replaceable units
119