IBM 8671 - Eserver xSeries 235, Maintenance And Troubleshooting Manual

Page: 109 / 222

9. Replace the plastic shield covering the bottom portion of the system board.
10. Reinstall the adapter-support bracket in the server (see “Removing and
installing the adapter-support bracket” on page 58).
Note: You must reinstall the air-baffle assembly when you reinstall the
adapter-support bracket. Make sure that no cable is under the
adapter-support bracket or interferes with the center fans.
Important: To ensure proper cooling and server operation, you must keep the
air-baffle cover closed.
11. Reinstall the adapters and plastic dividers that you removed, and reconnect the
internal cables that you disconnected.
12. Reinstall the server cover (see “Installing the server bezel and left-side cover
(tower model)” on page 100 or “Installing the server bezel and top cover (rack
configuration)” on page 103).
Note: You must wait approximately 20 seconds after you plug the power cord
of your server into an electrical outlet before the power-control button
becomes active.
13. Start the Configuration/Setup Utility program and set configuration parameters
as needed (see “Starting the Configuration/Setup Utility program” on page 15).
Completing the installation
To complete your installation, you must reinstall the bezel, reinstall the server cover,
reconnect all the cables that you disconnected earlier and, for certain options, run
the Configuration/Setup Utility program. Follow the instructions in this section.
Attention:
v
For proper cooling and airflow, replace the server cover before or shortly after
turning on the server. Operating the server for extended periods of time (over 30
minutes) with the server cover removed might damage server components.
v
To ensure proper server operation, do not remove the air-baffle assembly from
the server except when installing or removing the components that are under the
air-baffle cover.
Note: If you have just plugged the power cords of your server into electrical outlets,
you will have to wait approximately 20 seconds before pressing the
power-control button.
Chapter 4. Customer replaceable units
99