IBM 8671 - Eserver xSeries 235, Maintenance And Troubleshooting Manual

Page: 111 / 222

The following illustration shows how to install the left-side cover on the tower model
server.
Slots
Left-side cover
Complete the following steps to install the server left-side cover:
1. Before installing the cover, check that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2. Place the bottom lip of the left-side cover over the bottom edge of the server
chassis.
3. Rotate the left-side cover to a vertical position, inserting the tabs at the top of
the left-side cover into the matching slots in the server chassis.
4. Slide the left-side cover forward until it locks in place.
5. If you disconnected any cables from the back of the server, reconnect the
cables; then, plug the power cords into properly grounded electrical outlets.
Note: If necessary, see “Input/output connectors” on page 108 for connector
locations.
Chapter 4. Customer replaceable units
101