IBM 7133 D40, Service Manual

Page: 286 / 306

-B card=mode
Modifies the specified bypass cards to be in the given modes. The valid values
for the mode parameter are:
v
Automatic
v
Bypass
v
Inline
v
Open
Valid values for the card parameter are 1, 4, 5, 8, 9, 12, 13, 16.
-S Resets the “exchanged” flag of the selected FRU.
-S d[drive_bay ...]
Resets the flag for the selected drive bay. Valid values for drive_bay are 1, 2,
3, and so on.
-S b[card ...]
Resets the flag for the bypass card. Valid values for card are 1, 4, 5, 8, 9, 12,
13, 16.
-S p[PSU ...]
Resets the flag for the selected PSU. Valid values for PSU are 1, 2.
-S r Resets the flag for the remote power-on control (RPO).
-S c Resets the flag for the controller card.
-S o Resets the flag for the operator panel.
-T threshold=value
Modifies the specified temperature thresholds to the given values. The valid
values for the [threshold] parameter are:
lowarn
The low-temperature warning threshold.
hiwarn The high-temperature warning threshold.
The value parameter is a temperature in degrees C.
Examples
v
To display the status of all bypass cards on enclosure0, give the command:
ssaencl -l enclosure0 -b
v
To display the status and VPD of the controller card in enclosure0, give the
command:
ssaencl -l enclosure0 -c -v
v
To modify the ID for enclosure0 to R2D2, give the command:
ssaencl -l enclosure0 -I R2D2
v
To display the contents of disk bay (slot) 8 in enclosure0, give the command:
ssaencl -l enclosure0 -d 8
268
7133 Models D40 and T40 Service Guide