Later-Type Power Switch and Cable Assembly
Step 1. If not already done, open the back cover (see “Covers” on page 138).
Step 2. Remove all power from the 7133 (see “Power (Model T40)” on page 148).
Step 3. Refer to Figure 105.
Step 4. Unplug the two power cables
2
from the power supply assemblies.
Step 5. Remove the screw
1
from the AC connector block.
Step 6. Lift the AC connector block and turn it counterclockwise to remove it from its
mounting lug.
Step 7. Place the AC connector block and its attached power cables onto the flat
surface inside the 7133.
Step 8. Go to the front of the 7133.
Step 9. If not already done, open the front cover (see “Covers” on page 138).
Step 10. Remove the front bezel assembly (see “Front Bezel Assembly (Model T40)”
Figure 105. Removing the AC Connector Block
Chapter 3. Removal and Replacement Procedures
193
Summary of Contents for 7133 D40
