IBM 7133 D40, Service Manual

Page: 176 / 306

Step 6. Refer to Figure 80
Step 7. Close the handle
1
. Press it in until you hear a click. This action pushes the
module fully home.
Step 8. If you are installing a dummy disk drive module, go to step 10 on page 159.
If you are installing a disk drive module, go to step 9.
Step 9. If the 7133 is switched on:
a. Ensure that the Check light
3
comes on immediately.
v
If it comes on, go to step 9b.
v
If it does not come on, go to “MAP 2010: 7133 Models D40 and T40 –
START” on page 87. When you have solved the problem, return to this
section, and go to step 9b.
b. Check whether the Check light goes off after approximately two seconds.
v
If the Check light goes off, go to step 9c on page 159.
v
If the Check light remains on, the disk drive module might be in Service
mode. If the disk drive module is in Service mode, reset Service mode
(see the chapter about SSA service aids in the user or maintenance
information for your using-system SSA attachment hardware).
v
If the Check light goes off, go to step 9c on page 159.
v
If the Check light remains on, go to “MAP 2010: 7133 Models D40 and
T40 – START” on page 87. When you have solved the problem, return
to this section, and go to step 9c on page 159.
1 2 3
Figure 80. Closing the Handle of a Module
158
7133 Models D40 and T40 Service Guide