Step 13. Do the same actions with the latch
1
to unplug the disk drive status lights
flexible circuit from the controller card assembly.
Step 14. Remove the front mounting screws
5
.
Step 15. Note: For a translation of the following notice, see the 7133 Serial Disk
Systems and SSA Adapters: Translated Safety Notices manual.
CAUTION:
Do not attempt to lift the 7133 by yourself. Ask another service
representative for aid.
With aid from another service representative, pull the 7133 forward and
remove it from the rack.
Step 16. Reinstall the 7133 in the reverse sequence.
Notes:
a. When you reinstall the 7133 into the rack, reinstall the front mounting
screws before you reinstall the back clamp plates or brackets. Reinstall
the front mounting screws in the following sequence:
1) Install lower left-hand front mounting screw. This screw locates the
7133 laterally. Do not fully tighten the screw yet.
2) Install the other three front mounting screws. Do not fully tighten the
screws yet.
3) Fully tighten the lower left-hand front mounting screw.
4) Fully tighten the other three front mounting screws.
b. Go to the back of the 7133.
Chapter 3. Removal and Replacement Procedures
227
Summary of Contents for 7133 D40
