IBM 7015-R30, Installation And Service Manual

Page: 282 / 300

Service Guide
D-24
Error
Number
Description Failure
Percent
(%)
Failing
Function
Codes Source
408-060 K B94
B96 or
B97
50
50 Description: Main memory Knaizuk-Hartmann test error.
Action: Use MAP 0210.
408-080 K C63
C61 90
10 Description: Multi resources full test error.
Action: Use MAP 0210.
409-000 K ??? 100 Description: Planar vital part FATAL ERROR.
Action: Use MAP 0210.
409-008 K B94 or C64
or D28
100 Description: No 2MB available in MM. All memory banks FATAL
ERROR.
Action: Use MAP 0210.
409–050 K None None Description: This is not an error. This code indicates a change in
configuration, that NV-RAM has been reset, etc. No parts should
be replaced for this code.
409–051 K None None Description: This is not an error. This code indicates a change in
configuration, that NV-RAM has been reset, etc. No parts should
be replaced for this code.
409–052 T1 x K Firmware 100 Description: –12 stand–by VOLT error. x is the unit number.
409–052 T2 x K Firmware 100 Description: +12 stand–by VOLT error. x is the unit number.
409–053 T1 x K Firmware 100 Description: 485RX protocol error (lengths). x is the unit number.
409–053 T2 x K Firmware 100 Description: 485RX protocol error (time–out). x is the unit number.
409–053 T3 x K Firmware 100 Description: 485RX protocol error (checksum error). x is the unit
number.
409–054 T1 K Firmware 100 Description: Marginature error (ASIC VOLT).
409–054 T2 K Firmware 100 Description: Marginature error (CPU VOLT).
409–054 T3 x K Firmware 100 Description: Marginature error (+5 VOLT). x is the unit number.
409–055 T1 K Firmware 100 Description: VPD command error (read VPD).
409–055 T2 K Firmware 100 Description: VPD command error (write VPD).
409–056 K Firmware 100 Description: Marginature command error.
409–057 K Firmware 100 Description: Checksum logging not valid.
409–058 K Firmware 100 Description: Environment over temperature.
409–059 T1 K Firmware 100 Description: I2C bus error (wrong interrupt frame).
409–059 T2 x K Firmware 100 Description: I2C bus error ( unknown SIB interrupt). x is the unit
number.
409–059 T3 x K Firmware 100 Description: I2C bus error ( unknown interrupt source). x is the
unit number.
409–059 T4 x K Firmware 100 Description: I2C bus error ( unknown operator panel interrupt).
x is the unit number.
409-080 K C59
C60
C88 or C89
33
33
33 Description: BUMP access to OPP or OPP access to SIF failed.
Action: Use MAP 0210.
409-081 K C59
C88 or C89
50
50 Description: BUMP access to SIF failed.
Action: Use MAP 0210.
409-082 K C59
C60 80
20 Description: Operator panel cannot access the BUMP.
Action: Use MAP 0210.
Note: This problem can be caused by an incorrectly installed CEC.