IBM 7015-R30, Installation And Service Manual

Page: 155 / 300

Removal and Replacement
4-33
7. Remove the disk drive fan and media fan. Refer to the “Media Module Fans” removal
procedure on page 4-30 for information about removing the two fans.
8. Disconnect the SCSI cable connector on the rear of the disk drive docking connector
card.
9. Remove the two rear mounting screws attaching the media docking connector bracket to
the rear of the media module (these screws are not present on all media modules).
SCSI Cable
Connector
Mounting
Screws
Bottom of Media Module
Rear View of Media Module (upside down)
10.Remove the four mounting screws on the media docking bracket, and then lift the media
docking bracket out of the media module to access the SCSI cable connector on the
media docking connector card.
Mounting
Screws
Bottom of
Media Module
Rear of Media Module
Media Docking
Bracket