Removal and Replacement
4-17
Disk Drive
Removal
1. Do the “Front Bezel and Front Access Plate” removal procedure on page 4-15.
2. Remove the mounting screw attaching the media retainer bracket to the CPU enclosure,
and then remove the media retainer bracket.
3. Pull the disk drive toward you and out of the CPU enclosure.
4. If you are replacing only the disk drive and not the mounting bracket, disconnect the
power, address (R50 only), and data connectors from the disk drive.
5. Remove the four mounting screws attaching the disk drive to the mounting bracket, and
then remove the disk drive.
Mounting
Bracket
Disk Drive
Front View of CPU Enclosure
Mounting
Screws
Mounting
Screws
Media Retainer
Bracket (Shaded)
Mounting Screw
R50
R30, R40
Mounting Screw
Replacement
Note: If a new disk drive is being replaced, ensure that the SCSI address setting is the
same as the disk drive you removed.
The R50 CPU Enclosure can have two, one-inch high drives installed into the disk
drive bay or one disk drive that is more than one inch high.
Replace in the reverse order.
Summary of Contents for 7015-R30
