IBM 7014 T00, Manual

Page: 105 / 196

Figure 62. Replacing the side panel
3. Slide the top of the side panel into place and close the locking latches.
Note: If your rack uses ruggedized kit, you must install a securing screw into each side panel that was
installed. See “Ruggedized kit” on page 85.
4. If the security kit is installed, slide the security bar to the locked position.
Removing and replacing 7014-T00 or 7014-T42 trim panels
Racks that are installed with multiple processor drawer systems can use front trim panels instead of
doors. For racks that use trim panels, a reduced-interference panel type must be installed when certain
expansion unit models are present. Use the procedures in this section to remove the existing trim panels
from the rack and replace them with the reduced-interference panel type.
Removing the 7014-T00 or 7014-T42 trim panels
For racks that use trim panels instead of doors, a reduced-interference panel type must be installed when
certain expansion unit models are present. Use the procedure in this section to remove the trim panels.
About this task
To remove the existing rack trim panels, complete the following steps:
Procedure
1. Place both hands on the center of the right side trim panel.
Racks and rack features 91