Hyundai F4GE9454J*J604, Technical And Repair Manual

Page: 63 / 142

123023
Figure 77
Figure 78
-
Assemble exhaust manifold (1) providing new gaskets
(2).
Figure 79
123025
-
Assemble thermostat unit (2) including thermostat (4)
and gasket (3).
-
Tighten the screws to the prescribed couple.
Figure 80
-
Assemble injectors after having replaced the sealing
gasket (1).
75707
The screws (1) have been have been utilised to fix
the bracket (3).
Disassemble the bracket and reassemble
components from 1 to 5 as shown in the picture.
The gasket must be new.
1
-
Assemble cylinder covers (2) with the respective gaskets;
-
Fit the seal nods and tighten the screws fixing them to
the prescribed couple.
During assembly of injectors, verify that the injector
sphere is correctly positioned on the head housing.
Always replace the gaskets using new ones.
Check the threads of the fixing screws: there shall
be no evidence of wear or dirt deposit.
Seal nods shall have no visible deformation. In such
case provide for replacement with new nods.
The illustration of exhaust manifold may be not
matching
your model. Anyhow, described
procedure is applicable.
NOTE
87406
NOTE
NOTE
NOTE
(Demonstrative)
The shape and the size of the thermostat casing
vary according to the usage of the engine.
The illustrations therefore provide a general
guideline for the operation to be carried out.
The procedures described are therefore applicable. NOTE
SECTION 3 - AGRICULTURAL APPLICATION
29
F4GE N SERIES
Print P2D32N010 E Base - February 2009