Hyundai F4GE9454J*J604, Technical And Repair Manual

Page: 47 / 142

-
Loosen the two fixing screws (2) and disassemble
priming pump (1).
88102
Figure 13
Figure 14
-
Remove tappet caps:
Loosen the four fixing screws (1) and lift the caps (2);
remove the gaskets.
87406
On the cap there is a blow-by valve for the
lubrication oil vapours.
All the gaskets shall always be replaced during
assembly. NOTE
Figure 15
- Disassemble suction and exhaust manifolds: loosen the
8 screws (1) fixing the suction manifold plate to the
cylinder head
(two of them have already been
screwed-out since fixing the pipe brackets to the
injectors); from the exhaust manifold side;
loosen the (2) fixing screws; remove the gaskets.
87409
Figure 16
-
Disassemble rocker arm bearings; loosen the two fixing
screws (2) and remove the complete rocker arm bearing;
withdraw tappet rods. Repeat the operation for all the
remaining rocker arm bearings.
-
Disassemble water temperature transmitter (1).
125114
SECTION 3 - AGRICULTURAL APPLICATION
13
F4GE N SERIES
Print P2D32N010 E Base - February 2009