Hyundai F4GE9454J*J604, Technical And Repair Manual

Page: 113 / 142

70179
70180
70182
Figure 21
Figure 22
Figure 23
Figure 24
Check camshaft end float (1).
It shall be 0.23
±
0.13 mm.
Fit nozzles (2) and tighten the fastening screws (1) to the
specified torque.
Grind journals and crankpins if seizing, scoring or excessive
ovalisation are found. Before grinding the pins (2) measure
them with a micrometer (1) to decide the final diameter to
which the pins are to be ground.
It is recommended to insert the found values in the
proper table.
See Figure 24.
Undersize classes are: 0.250 - 0.500 mm.
Journals and crankpins shall always be ground to
the same undersize class.
Journals and crankpins undersize shall be marked
on the side of the crank arm No.1.
For undersized crankpins: letter M
For undersized journals: letter B
For undersized crankpins and journals: letters MB
FILL THIS TABLE WITH OUTPUT SHAFT JOURNAL AND CRANKPIN MEASURED VALUES
*Rated value
OUTPUT SHAFT
Measuring journals and crankpins
108487
NOTE
NOTE
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
17
F4GE N SERIES
Print P2D32N010 E Base - February 2009