Hyundai F4GE9454J*J604, Technical And Repair Manual

Page: 55 / 142

DIAGRAM SHOWING SEALING LOCTITE 5205
APPLICATION
It is necessary and essential to clean the surface to
be sealed in order to achieve excellent tight seal.
Apply sealing LOCTITE 5205 on the box in order
to form a kerbstone of a few mm. Diameter. It must
be uniform (no crumbs), with no air blisters, thinner
or irregular zones.
Any eventual imperfection shall be correct as soon
as possible.
Avoid using material in excess to seal the joint. Too
much sealing material would drop out on both
sides of the joint and obstruct lubricant passages.
Couplings must be assembled within 10 minutes
after completing the sealing operation.
-
Re-assemble the box (1) to the engine basement.
-
Tighten the fastening screws (2) to the same position
detected before disassembly.
87659
- Apply to the rear tongs hold (3) of the engine drive shaft
the part (6) of the tool 99346253, fix it with the screws
(1) and spline the new tight ring to it (2).
-
Place the part (5) on the part (6), tighten the nut (4)
until tight ring assembly (2) into the flywheel box is
completed.
Before assembly, always check that the threads of
the ports and of the screws have no evidence of
tear and wear nor dirt.
122588
84077
Figure 45
Figure 46
Figure 47
NOTE
NOTE
SECTION 3 - AGRICULTURAL APPLICATION
21
F4GE N SERIES
Print P2D32N010 E Base - February 2009