Installation Manual
2-58
Revision E
Hurco
Electrical Connections
Electrical connections for the AB6 are covered in this section. These
connections include the advance and retract sensor. There are also cable
connections between the power cabinet, control console, and gauge(s).
Two types of power cabinets are available for the AB6: the Small or
Standard power cabinets which have a Main board for advance retract
connections, and the Large power cabinet which contains a Relay board
for advance retract connections.
Warning
Before performing any electrical connections, become
familiar with the “Electrical Safety Guidelines” in the
“Introduction” chapter of this manual.
Small or Standard Power Cabinets with Main Board
The electrical connections require stripped wires to be inserted into the J8
connector in the Main Board. The following sections refer to the Main
Board J8 Connector. This removable 7-pin connector is located on the
Main board in the AB6 Small or Standard power cabinet (see the figure
below). This figure shows the Main board’s components.
Figure 2-45. Main Board with J8 Connector
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
