Installation
Autobend 6
November, 1999
2-113
Connecting the Incoming Power Line to the Plug
To connect the incoming power line to the plug follow these instructions:
1.
Remove the screw from the plug cover. Separate the plug into
two halves.
2.
Remove the two screws holding the strain relief clamp and
remove the clamp.
3.
Route the power line through the rubber gasket.
4.
Strip back 1/8" (3 mm) of insulation from each wire.
5.
Connect the neutral wire to the screw terminal with the “N”
label.
6.
Connect the ground wire to the screw terminal with the “E”
label.
7.
Connect the hot wire to the screw terminal with the “L” label.
8.
Replace the clamp and tighten the two screws.
9.
Replace the plug cover and tighten the screw.
Connecting the Plug to the AB6 Power Cabinet
To connect the plug to the AB6 power cabinet follow these instructions:
1.
Connect the plug into the power receptacle located on the
right-hand side of the power cabinet.
2.
Lock the plug in place with the clamp spring.
3.
Route and secure the incoming power line where it will not
be damaged.
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
