Installation
Autobend 6
November, 1999
2-5
Power Cabinet
The AB6 power cabinet houses the electrical circuits that transfer energy
from the outside power source to the control console. Attach the AB6
power cabinet on the same side that the press brake’s control box is
attached if possible.
There is a warning decal on the AB6 power cabinet’s door that cautions
the operator to disconnect main power before opening it. The decal also
warns about the possibility of personal injury. When it is necessary to
access the electrical circuits inside the AB6 power cabinet, remove the
cabinet’s door.
Caution
Consider cable runs when selecting the area to mount the AB6
power cabinet. Never install cables so they interfere with the press
brake’s throat. It is important to allow clearance for incoming power
and second axis components (for example, linear scale assemblies
and Y-axis motor drive units).
Follow these instructions to mount the AB6 power cabinet onto the press
brake:
1.
If possible, position the power cabinet on the same side as
the press brake’s control box.
2.
Mount the power cabinet in a clear area on the press brake.
Do not mount it in the shaded areas as shown in the figures
on the following pages.
3.
Use the power cabinet as a template to locate and mark the
centerline of its four (4) mounting holes. Allow at least 6"
(150 mm) of clearance between the bottom of the power
cabinet and the floor for plugging in the cables.
4.
Drill the four (4) mounting holes, using the drill bit and tap
sizes indicated in the drawing on the following page.
5.
Clean the surface of the press brake and bolt the power
cabinet in position.
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
