Hurco AB6, Installation Manual

Page: 18 / 165

Introduction
Autobend 6 November, 1999 1-3
Safety Precautions
This section is included to address the safety hazards normally
encountered with the intended use and the foreseeable misuse of the AB6.
This product was intended to be used by trained operators who create
metal bending programs either on the console or on an off-line system.
These operators then run the programs to bend metal. While running the
machines, the operators must use their experience and training to make
any necessary adjustments and improve the efficiency of their programs.
This safety section describes common problems seen by Hurco Service
representatives with suggestions for avoiding or dealing with the problems
in a safe manner. However, this information is not an exhaustive
description of all of the possible misuses of the machine nor is it a
substitute for operator training, skill, and good judgment. Hurco does not
accept any liability for operator error.
It is important to follow all of Hurco and the press brake manufacturer’s
safety precautions to avoid personal injury, damage to the machine, and
unproductive downtime. Installers must also follow the safety regulations
of their shops.
Errors in setup or programming can damage the press brake and cause
severe personal injury. The Hurco AB6 does not reduce or eliminate the
need for its users to follow the safety and operating instructions the press
brake manufacturer provides. Do not ignore safety policies and
safeguarding circuits of the press brake’s controls.
Be familiar with the following safety issues regarding the press brake and
the AB6:
•
Control Console Stop Button
•
Gauges
•
Power Cabinet and Console Location
•
Axes’ Orientation