Hurco AB6, Installation Manual

Page: 36 / 165

Introduction
Autobend 6 November, 1999 1-21
The Programming keys are grouped with the Data Entry keys.
Programming, Job, Bend, and Run keys have dedicated LEDs to show
whether their state is Active (On) or Stand-by (Off). Use the Programming
and Data Entry keys to perform these functions:
Programming Key Function
Job Activate the Job display and input new jobs.
Bend Activate the Bend display and input bend number.
New
Bend Activate the Bend display and input a new bend number.
Funct Used in conjunction with other programming and data entry keys to enable
special functions.
Ram
On Select ram control status (On/Off).
Data Entry Key Function
Enter Enter selected data, move cursor the next prompt, transfer Die Top and Die
Bottom positions, and transfer the Teach position.
IN/MM Select measurement unit (inch or metric). This key is used with the Funct
key.
Next Select the next job parameter or bend parameter, depending on mode.
Back Select the previous job parameter or bend parameter, depending on mode.
Insert Insert a new bend.
Delete Delete the displayed job or bend.
+
Input positive data entries or perform Calculator functions.
-
Input negative data entries or perform Calculator functions.
Clear Clear displayed data.
0-9 Use the number keys to input numerical values, or to perform special
functions when used in conjunction with the Funct key.
Important
Refer to the Programming and Operations manual for more
information about calibration and job programming.