Hurco AB6, Installation Manual

Page: 26 / 165

Introduction
Autobend 6 November, 1999 1-11
Operators’ Responsibilities
To avoid serious personal injury, damage to the AB6, and unproductive
downtime, pay careful attention to safety precautions and proper
maintenance. Press brake operation is often a dangerous task, so operators
must stay alert and be aware of potential hazards. Operators must also
follow the safety regulations of their shops.
Training
All operators must be trained in order to operate an AB6. The operators
who are going to run the press brake must be trained by Hurco or an
authorized representative. Before attempting to run the control, study this
manual and become familiar with the functions and safety features.
While studying the manual, make special note of the caution and warning
messages in the manuals and all warning and instruction plates/decals on
the AB6 and the press brake.
Clothing and Other Apparel
Operators should always wear eye protection and safety shoes while in the
work area. Safety glasses with side shields are recommended. Do not wear
items such as loose-fitting clothing, watches, necklaces, rings, and
neckties that could become caught in the moving parts of the AB6 and
press brake.
Personal Care
Operators must follow established working practices and personal hygiene
standards. As part of this effort, they must avoid frequent or prolonged
skin contact with fluids and oils on the sheet metal. Some operators wear
gloves or use a special hand cream to protect their hands from these
chemicals. If operators get chemicals on their hands, they must wash their
hands immediately upon leaving the AB6 and pressbrake and before taking
a break. They must also change clothing that has become contaminated
with fluids and oils.
For complete information about handling industrial chemicals used in
machining, refer to the international Control of Substances Hazardous to
Health (COSHH) materials from the chemical suppliers.