Installation Manual
2-36
Revision E
Hurco
2.
Locate the centerline of both the forward and rear mounting
brackets’ holes (see the figure below). Mark the centers of
the mounting holes.
3.
Carefully drill and tap the eight bolt holes to the
recommended sizes and dimensions (see the figure below).
Figure 2-28. Side View of Typical Press Brake
4.
Loosely attach the gauges’ mounting brackets to the side
frames, using the screws and flat washers provided.
5.
Remove the Autobend S8 name plates at the rear of each
gauge.
6.
To prevent each gauge cable (harness) from becoming
entangled with the lead screw when the gauges are mounted
vertically, secure the cable to the gauge frame with tie wraps.
a.
Use the 15/64" drill bit and drill one hole in each gauge
frame for connecting the tie wraps. Each hole should be
located 8" from the rear and 1/2" up from the bottom.
b.
Insert the self tapping screws, and attach one tie wrap to
each frame.
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
