Installation
Autobend 6
November, 1999
2-43
S6, S7, S8, and Vertical S8 Gauges
Follow these steps to install vertical supports to S6, S7, and S8 gauge bars:
1.
Adjust both vertical supports to the same length.
2.
Placing the clamp handle and T-nut to the rear, slide the
vertical supports an equal distance into the T slot in the
bearing blocks.
3.
Tighten the clamp handle slightly when in position.
Where can we go from here?
Proceed to either the “Y-Shaped Rigid Gauge Bar” or “Tilting Gauge
Bar” section of this chapter.
Summary of Contents for AB6
Page 3: ...iv Revision E Hurco...
Page 5: ...vi Revision E Hurco...
Page 13: ...Installation Manual xiv Revision E Hurco...
