FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
3 Hardware Installation
Issue 10 (2019-12-20)
Copyright © Huawei Technologies Co., Ltd.
188
The fingerprint and card reader is connected to the access actuator by a network cable.
Step 5
Check that cables are correctly connected.
Step 6
Secure the fingerprint and card reader to the baseplate, as shown by (5) and (6) in
----End
3.11.18 (Optional) Installing an In-Room Card Reader with a
Keypad
Context
The BOM number of a card reader with a keypad is 02070172.
It is recommended that the device be installed outside a room 1.4-1.6 m above the floor.
Do not install the product in a place with heavy dust or exposed to sunlight.
Procedure
Step 1
Remove the screws (set aside) from the card reader with a keypad and take off the baseplate,
as shown by (1) in
Figure 3-224
Installing a card reader with a keypad
Step 2
Mark the mounting holes using a marker, and drill holes using a hammer drill.