Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Chapter 3 Installing Cabinet and Cabinet Equipment
Huawei Technologies Proprietary
3-16
3.4.4 Installing Built-in Batteries
The built-in batteries are installed after the batteries are connected with each other. For
installation method, see section 5.10, “Installing Built-in Batteries".
Note:
If the battery power is available, built-in batteries can be spared.
3.4.5 Installing Built-in Transmission Equipment
The BTS3606A can employ transmission modes such as SDH, HDSL, microwave, or
E1/T1. In addition to E1 transmission mode compliant with G.703 standard, it also
provides space and interfaces for built-in transmission equipment. You can install the
transmission equipment as needed.
The BTS3606A cabinet must meet the following requirements:
z
The reserved space in the cabinet is 19 in. wide, 6 U high, and 600 mm (24 in.)
deep. (1 U = 44.45 mm, IEC297)
z
The cable outlets are also reserved for cables of microwave, SDH, and E1
equipment.
z
The BTS3606A can provide –48 V DC power for the transmission equipment.
3.5 Installation or Removal of Auxiliary Battery Cabinet
Doors
The front and rear doors of the auxiliary battery cabinet have been installed before
delivery. During the installation and maintenance of the cabinet, it is not necessary to
reinstall the rear door.
The following introduces how to open the front door and how to remove the rear door.
The installation procedures of the rear door are reverse of the removal procedures.
After finishing the installation, turn the burglary-resisting handle back to the original
position.
3.5.1 Opening the Front Door
Caution:
Before closing the door, lift and slide the support bar along the rail.
