Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Chapter 5 Installing Cables
Huawei Technologies Proprietary
5-8
z
RF jumper to feeder
z
RF cables between CDDU/CHPA/CTRM (single-channel)
z
RF cables between CDDU/CMPA/CMTR (multi-channel)
5.3.1 Connecting RF Jumper to Feeder
If the BTS3606A operates in diversity receiving mode using two antennas, the
connecting procedure is as follows:
1)
Remove all screws on the inlet/outlet and keep them properly, as shown in Figure
5-3.
(1) Screws on the inlet/outlet
Figure 5-3
Inlet/outlet of RF cables
2)
Turn over the inlet/outlet panel, as shown in Figure 5-4.
(1) Internal screws on the inlet/outlet
Figure 5-4
Inlet/outlet panel after turnover
3)
Remove the four screws inside, as shown in Figure 5-4.
4)
Lead the Din connector of the RF jumper to the inlet according to the inlet ID and
connect it to the feeder under the base.
