Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Chapter 1 Installation Preparations
Huawei Technologies Proprietary
1-2
1.2 Tools and Instruments
Table 1-2 lists the tools and instruments needed for the installation.
Table 1-2
Tools and instruments
Measuring
instruments
Long tape, 50 m ribbon tape, 5 m measuring tape,
and 400 mm level bar
Marking
instruments
Marking pen, ink fountain, and pencil
Drilling
tools
Percussion drill with matching bits of
φ
6,
φ
8,
φ
10,
φ
12,
φ
14, and
φ
16; dust cleaner
Clamping
tools
Flathead screwdrivers (M3 – M6)
Cross screwdrivers (M3 – M6)
Adjustable wrenches
Socket wrenches (M6, M8, M12, M14, M17, and
M19)
Double offset ring spanner (M6, M8, M12, M14, M17,
and M19)
Combination wrenches (M17 and M19)
A set of inner hexagon spanners
Special wrench
Pliers
A pair of sharp nose pliers, a pair of diagonal pliers, a
pair of pincer pliers, electric hand drill, file, hacksaw,
crowbar, rubber hammer, and nail hammer
General
tools
Auxiliary
tools
Hairbrush, a pair of tweezers, paper knife, bellow,
plumb, soldering iron, tin wires, fork, ladder, heat
blower, solder absorber, insulating tape, power
connector board with 3 single-phase sockets, 3
two-phase sockets, and 3 three-phase sockets
(current capacity
>
15 A)
Special
tools
An earth resistance tester, antistatic wrist strap, a pair of antistatic
gloves, wire stripper, a clamping pincers, a feeder cutter, a pair of
crimping pliers for SMB, RJ-45 connector crimping pliers, wire
punchdown tool, wire cutter, a non-conductive screwdriver, safety
knife, stripper for 75
Ω
coaxial cables, a pair of connector crimping
pliers for 75
Ω
coaxial cables, and a pair of multi-purpose crimping
pliers
Instruments
A multi meter, 500 V megaohm meter (for testing the insulation
resistance), BER tester, and optical power meter
