Step 2
Connect the connectors on the other end of the PS/2 cable to the keyboard and mouse.
Step 3
Connect the DB15 connector on one end of a VGA cable to the VGA port on the rear panel of
the server. Tighten the screws on both sides of the connector to secure the cable.
Step 4
Connect the other end of the VGA cable to the VGA port on the monitor. Tighten the two
screws on the connector to secure the cable.
Figure 3-21
Connecting a USB-to-PS/2 cable and a VGA cable
----End
3.5.2 Connecting a Network Cable
Connect a network cable in the following scenarios:
l
The network needs to be set up over a gigabit Ethernet (GE).
l
You want to log in to the iMana/iBMC of the server using the management network port
for device management.
l
One or more network cables do not work.
l
A network cable needs to be replaced if the existing network cable does not meet length
requirements after a device is replaced or moved.
Conditions:
l
Use a network cable tester to check that the new network cable works properly.
l
Check that the new network cable is of the same model as or compatible with the
network cable to be replaced. Determine whether they are straight-through or crossover
cables.
l
Before installing a network cable to a network port, check that the network cable
connector is intact and the pins have no sundries or deformation.
The following tools are available:
l
Phillips screwdriver: used to tighten screws
5288 V3 Server
User Guide
3 Installing and Removing the 5288 V3
Issue 26 (2018-11-19)
Copyright © Huawei Technologies Co., Ltd.
70
