The following command deletes all routing table entries for virtual interface
eth0:1
on file serving
node
s2.hp.com
:
<installdirectory>/bin/ibrix_nic -r -n eth0:1 -h s2.hp.com -D
Deleting a network interface
Before deleting the interface used as the cluster interface on a file serving node, you must assign
a new interface as the cluster interface. See
“Changing the cluster interface” (page 65)
.
To delete a network interface, use the following command:
<installdirectory>/bin/ibrix_nic -d -n IFNAME -h HOSTLIST
The following command deletes interface
eth3
from file serving nodes
s1.hp.com
and
s2.hp.com
:
<installdirectory>/bin/ibrix_nic -d -n eth3 -h s1.hp.com,s2.hp.com
Viewing network interface information
Executing the
ibrix_nic
command with no arguments lists all interfaces on all file serving nodes.
Include the
-h
option to list interfaces on specific hosts.
<installdirectory>/bin/ibrix_nic -l -h HOSTLIST
The following table describes the fields in the output.
Description
Field
File serving node for the standby network interface.
BACKUP HOST
Standby network interface.
BACKUP-IF
File serving node. An asterisk (*) denotes the management console.
HOST
Network interface on this file serving node.
IFNAME
IP address of this NIC.
IP_ADDRESS
Whether monitoring is on for this NIC.
LINKMON
MAC address of this NIC.
MAC_ADDR
IP address in routing table used by this NIC.
ROUTE
Network interface state.
STATE
Network type (cluster or user).
TYPE
When
ibrix_nic
is used with the
-i
option, it reports detailed information about the interfaces.
Use the
-h
option to limit the output to specific hosts. Use the
-n
option to view information for a
specific interface.
ibrix_nic -i [-h HOSTLIST] [-n NAME]
66
Maintaining the system
