HP StorageWorks 6000 - Virtual Library System, User Manual

Page: 36 / 358

Attach Rails to the Node
To attach the rails to the node:
1. Align the rail with the node so that the word “FRONT” on the rail is seen right-side-up and at the
front of the node.
Figure 6 Attaching rails to the node
.
2. Align the holes in the rail with the round tabs on the side of the node.
3. Put the rail onto the node with the tabs extending into the holes on the side of the rail, then slide
the rail toward the front of the node until the tabs are locked into the rail.
4. Perform these steps again to Install the other rail on the other side of the node.
Install Appliance in Rack
1. Align the rails on the node with the rails in the rack.
2. Slide the node fully into the rack.
The rails on the node will lock into the rails on the rack.
3. With the node fully seated in the rack, tighten the thumbscrews just until the node bezel is secured
to the rack.
Installing the VLS6200 Node into a Rack
NOTE:
If you are installing the node into a telco rack, order the appropriate option kit at the RackSolutions.com
web site:
http://www.racksolutions.com/hp . Follow the instructions on the web site to install the rack
brackets.
Install the node in the rack as follows:
Hardware Installation 36