HP StorageWorks 6000 - Virtual Library System, User Manual

Page: 212 / 358

Usage
1
Command
Where the options are:
-in <s>
- Restores the VLS virtual library configuration and network settings from
the specified external configuration file.
-h
- Displays command usage information (optional)
restoreAllConfig
1
<s> = string; <n> = number; <f> = filename
Monitoring Commands
Use the CLI commands in CLI monitoring commands to:
• View the VLS health status
• View or delete notification alerts
• Add, view, or delete E-mail servers to route notification alerts
• Add, view, or delete E-mail addresses for notification alerts
• Add, view, or delete SNMP management consoles to receive notification alerts
Table 11 CLI monitoring commands
Usage
1
Command
Returns the VLS health status as a number (0-good, 1-degraded, 2-critical, 3-failed,
4-missing).
getHealth
Returns information about the VLS displayed on the Identity Tab window.
getChassis
Returns information on the node. Where the options are:
-a <s>
- Node name (Head_0, ...) (required)
-h
- Displays command usage information (optional)
getNode
Returns the list of nodes in the VLS.
getNodeNames
Returns fault information for the specified node. Where the options are:
-a <s>
- Node name (Head_0, ...) (required)
-h
- Displays command usage information (optional)
getNodeFault
Returns the current configuration of the specified array.
Note: This command returns the disk array name (disk array IP address), its health
state, and a listing of its major components. With the verbose option turned on,
a much more comprehensive report is produced.
A "rack" value of 0 indicates that the disk array is located in the primary or only
rack associated with the system.
Where the options are:
-a <s>
- IP address (required)
-h
- Displays command usage information (optional)
getArray
Returns the IP address of the disk arrays.
Where the options are:
-a <s>
- Storage pool name (StoragePool_#) (optional)
-h
- Displays command usage information (optional)
getArrayNames
CLI Command Set 212