HP ProCurve 530 NA, Management And Configuration Manual

Page: 119 / 556

5-35
General System Configuration
Configuring SNMP
1. Click
Management > SNMP
and select the
Traps
tab.
2. Under the Trap Groups, check or uncheck the required traps boxes.
3. Click
Update
.
SNMP Trap Hosts
The SNMP – Trap Hosts screen allows configuration of the following SNMP
trap parameters:
■
Trap Destination Host (1 to 3): Enables/Disables recipients (up to
three) of SNMP notifications. For each destination, enter the IP address
or the host name, and the community name.
■ IP Address:
Specifies the IP address or the host name (from 1 to 20
characters) for the recipient of SNMP notifications.
■
Community Name: The community string sent with the notification
operation. (Maximum length: 32 characters)
■ [Update]: Updates the Trap settings.
Figure 5-7. Configuring SNMP Trap Destinations
To Configure SNMP Trap Destinations:
1. Click
Management > SNMP
and select the
Trap Hosts
tab.
2. To set trap destinations, click
Trap Destination Host 1
,
2
, or
3
.