ENWW
TCP/IP Configuration 71
To set configuration parameters, you must set up a Telnet session
from your system to the HP Jetdirect print server.
1. Type the following at the system prompt:
telnet <IP address>
where
<IP address>
is the IP address listed on the Jetdirect
configuration page. See
Chapter 9
.
2. A connection to the HP Jetdirect print server will be displayed.
If the server responds with “
connected to IP address
”, press
Enter
twice to make sure that the Telnet connection is
initialized.
3. If prompted for a user name and password, enter the correct
values.
By default, the Telnet interface does not require a user name or
password. If an administrator password has been set, you will
be prompted for a user name and this password before you can
enter and save Telnet command settings.
4. By default, a Command Line interface is provided. To configure
parameters using a Menu interface, enter
Menu
. For more
information, see “
User Interface Options
”.
For a list of supported commands and parameters, see “
Telnet
Commands and Parameters
”.
User Interface Options
The HP Jetdirect print server provides two interface options to
enter Telnet commands: a
Command Line Interface (Default)
and
a
Menu Interface
.
