HP 9000 rp3410, User'S & Service Manual

Page: 190 / 254

Chapter 6
Removing and Replacing Components
Removing and Replacing a Dual Processor Module
190
Figure 6-43 Dual Processor Module Removal and Replacement
Installing a Dual Processor Module
Either one or two dual processor modules are located on the system board. Module #1 is located to the right of
the system board and module #2 (when installed) is located on the left of the system board next to the bridge
assembly. In a 1P/1C or 1P/2C configuration, the one dual processor module must be installed in the CPU0
socket.
Each dual processor module has an associated power pod that is required.
Install a dual processor module as follows:
Step 1. Power off the server and disconnect power and external cables.
Step 2. Remove the top cover. (See “Removing and Replacing Server Covers and Bezel” on page 151.)
Step 3. If you are replacing a dual processor module, remove the old module as described in the previous
procedure.
Dual
Proc #1
(in Socket
CPU0)
Dual
Proc #2
(in socket
CPU1)
Power
Pod # 1
Power
Pod # 2