HP 64782, User Manual, Page: 99 / 554

To modify a configuration section
1
Start the emulator configuration interface.
2
Click on a section name in the configuration interface top-level dialog
box.
3
Use the section dialog box to make changes to the configuration.
As soon as you change a configuration option, the change is recorded (as
seen by the "Changes Not Loaded" message in the top level dialog).
If you’re using the Softkey Interface:
The configuration questions in the "General Items" section are the first
to be asked.
To access the questions in the "Reconfigure Internal Registers"
section, answer "yes" to the "Reconfigure internal registers?" question.
To access the questions in the "Memory Map" section, answer "yes" to
the "Modify memory configuration?" question.
To access the questions in the "Emulator Pod Settings" section,
answer "yes" to the "Modify emulator pod configuration?" question.
To access the questions in the "Debug/Trace Options" section, answer
"yes" to the "Modify debug/trace options?" question.
4
Apply the configuration changes to the emulator.
To apply configuration changes to the emulator
•
Click the "Apply to Emulator" button in the top-level dialog box.
Loads the configuration changes into the emulator. Status text to the right
shows whether the load was successful.
You can apply configuration changes to the emulator at any time (even while
section dialog boxes are open). This lets you verify changes without closing
section dialog boxes.
The "Apply to Emulator" button does not store configuration changes to a file.
When you exit the configuration interface and there are configuration
changes that have not been stored, you are asked whether you want to store
the changes, exit without storing, or cancel the exit.
Configuring the Emulator
To modify a configuration section
98