HP 64782, User Manual, Page: 197 / 554

To start a trace measurement
•
Choose Trace
→
Everything .
•
Using the command line, enter:
trace
When you use the
trace
command without any options, the analyzer begins
recording processor bus cycles immediately, and continues until the trace
buffer is filled. In the default trace configuration, the analyzer stores all bus
cycles.
If you are using the deep analyzer, the depth of the trace list buffer depends
on whether or not you installed memory modules on the analyzer card, and
the capacity of the memory modules installed. Refer to the Hewlett-Packard
MC6833x Emulator/Analyzer Installation/Service/Terminal Interface
Guide
for details. If you are using the 1K analyzer, the trace list buffer is 512
or 1024 states deep (depending on whether or not you turn on the state/time
count). See "To count states or time" in this chapter.)
Example
From the demo directory /usr/hp64000/demo/debug_env/hp64749, start the
demo program and trace from the program start:
Startemul
reset
trace
run from transfer_address
Using the Emulation Analyzer
To start a trace measurement
196