horiba OCMA-500, Instruction Manual

Page: 43 / 141

Preparation
23
Condition settings
Standard calibration conditions and measurement conditions are set by default in the product.
Once the warm-up icon has turned off, calibration and measurement can be started
immediately.

Calibration condition settings
The default settings for the calibration conditions and the pages to refer to for the setting
procedures are shown below.

Measurement condition settings
The default settings for the measurement conditions and the pages to refer to for the setting
procedures are shown below.
Measurement
condition
Default setting Setting procedure page
Span Point 200.0 mg/L "Span Point" (page 81)
Extraction Time 40 sec "Extraction Time" (page 81)
Separation Time 30 sec "Separation Time" (page 82)
Number of Purge 2 time "Number of Purge" (page 82)
Calib. Mode AUTO "Calib. Mode" (page 83)
Measurement
condition
Default setting Setting procedure page
Extraction Time 40 sec "Extraction Time" (page 72)
Separation Time 30 sec "Separation Time" (page 72)
Fill Cell Time 60 sec "Fill Cell Time" (page 73)
Meas. Limit 300 sec "Meas. Limit" (page 73)
Drainage Time 30 sec "Drainage Time" (page 74)
Number of Purge 2 time "Number of Purge" (page 74)
Meas. Mode AUTO "Meas. Mode" (page 75)
Measurement Unit mg/L "Measurement Unit" (page 75)
Solvent Vol. 8.0 mL "Solvent Vol." (page 76)
Sample Vol. 16.0 mL "Sample Vol." (page 76)
Zero Shift Value 0.0 mg/L "Zero Shift Value" (page 77)
Use Light ON "Use Light" (page 77)
Confirm Save AUTO "Confirm Save" (page 78)
Save Memo OFF "Save Memo" (page 78)
Display Negative OFF "Display Negative" (page 79)
Display Raw Data OFF "Display Raw Data" (page 79)