horiba HU-200TB-W SS-120-W, Instruction Manual

Page: 42 / 109

Operation
30
r1 to r3
Contact output setting: R1 to R3
Tip
The other relays can be set in the same manner.
Reference
Refer to “ Control targets and their available options ” (page 48) for the options available
for the selected control target.
42
1.tyPE Contact output type setting Specify the contact output type (Control target).
non, AL,
HoLd, CLn,
CAL
non 42
1.HorL Control direction setting
Specify whether to perform control using the
upper limit operation or lower limit operation.
Note:
This is displayed when “1.tyPE” is set to “AL”.
Hi, Lo Hi 42
1.rng
Selection of decimal point
position (range) for alarm
setting value
Select the optimal position of the decimal point
(range) for the alarm settings.
Note:
This is displayed when “1.tyPE” is set to “AL”.
10.00,
100.0, 1000
100.0 42
1.SEt Alarm value setting
Specify the alarm value.
Note:
This is displayed when “1.tyPE” is set to
“AL”. The item of sub display depends on
which ever “10.00”
*1
or “100.0”
*2
or
“1000”
*3
in “1.rng” is selected.
*1
0.00 to
10.00
10.00
42
*2 0.0 to 100.0 2.000
*3 0 to 2000 2000
1.dt
Contact output delay time
setting
Specify the delay time in seconds from when
an alarm or hold state occurs until a contact is
output.
Note:
This is displayed when “1.tyPE” is set to “AL” or
“HoLd”.
0 to 600 (s) 0 42
1.CLn.t
Output type setting for
cleaning
Specify the cleaning output type.
Note:
This is displayed when “1.tyPE” is set to “CLn”.
CLn, trg CLn 42
1.CAL.t
Output type setting for
calibration
Specify the calibration contact type.
Note:
This is displayed when “1.tyPE” is set to “CAL”.
CAL, trg,
CAL.E
CAL 43
FAiL Error alarm (FAiL) output setting: RF 43
F.SC
Setting of FAiL output
when abnormality is
detected during self-check
Specify whether or not to output a FAiL when
an abnormality is detected during self-check.
yES, no yES 43
F.oF
Setting of FAiL output
when measured value
exceeds full-scale range Specify whether or not to output a FAiL when
the measured value exceeds the full-scale
range.
yES, no no 43
F.CAL.E
Setting of FAiL output
when a calibration error
occurs (Calibration error is
regarded as “FAiL”) Specify “yES” when a FAiL is to be output if a
calibration error occurs. In this case, a
transmission output is held in the meas mode
until the FAiL is cancelled.
yES, no no 43
Display Item Description
Setting
range
Initial
value Refer
to page