Data
85
Disposing of the printed boards after classifying their parts
When it is required to classify the parts of the printed boards before disposing of them,
disassemble them referring to the figure shown below.
Tool
Phillips screwdriver
How to disassemble
1.
Check that the power is OFF.
2.
Remove all the wires on the terminal block that are connected to printed circuit
boards 35 and 44.
3.
Remove the four screws used to secure terminal cover 24.
4.
Remove spacer 43 in four places.
Printed circuit board 44 is exposed in the assembled state.
5.
Remove the one flat cable connected to the connector on printed circuit board 44.
6.
Remove spacer 32 in four places.
7.
Remove the two screws used to secure terminal cover 4.
Printed circuit board 35 is exposed in the assembled state.
8.
Remove the two flat cables connected to the connectors.
18 LCD holder
ADC12
43 Spacer
C3604BD
19 Case packing
Q
44 Printed circuit board (H4W-ANL-0x) Printed circuit board
20 Plunger packing R
Q
45 PTFE plate
PTFE
21 Parallel pin
SUS304
46 Protective sheet U
PVC
22 Terminal nameplate
PET
47 Upper hinge
ADC12
23 Terminal block information plate PET
48 Screw cap 2
Q
24 Terminal cover 4U
PC
49 FG mesh
Copper wire
25 Cable clamp
Q
50 Rating plate
PET
WARNING
Be sure to check that no electric power is supplied before starting the procedure.
No.
Name
Material
No.
Name
Material