Measurement
35
List of items displayed in the meas mode
Displays
Display
condition
Item
Description
Setting range
-
Main display screen
Displays the measured values, unit of measurement, and
type of turbidity standard substance.
Contact output check setup screen (display example when r1 is set)
Tip
The other relays can be set in the same manner.
Reference
Refer to “ Control targets and their available options ” (page 48) for the options available for the selected
control target.
When “non” is
set in “1.tyPE”
Relay setting
condition screen
(the numeral at the
lower left indicates
the relay number)
Relay 1 is not used.
Note:
“_ _ _ _” indicates that a relay is not used.
When “AL” is
set
Control value setup
screen
Displays the upper/lower limit setting value
for turbidity.
The set value can be changed.
Note:
The setting range changes with the position
of the decimal point.
0.00 to 10.00,
0.0 to 100.0,
0 to 2000
(degrees)
Delay time screen
Displays or is used to specify the delay time
in seconds.
0 to 600 (s)
When “HoLd” is
set
Relay setting
condition screen
(the numeral at the
lower left indicates
the relay number)
Retention time
screen
Retention time from the hold OFF is
displayed or changed in seconds.
0 to 600 (s)
When “CLn” is set in “1.tyPE”
When “CLn” is
set in “1.CLn.t”
Screen for indicating
that a contact is
output in a hold
state during and
after cleaning
Display only
-
When “trg” is
set
Screen for indicating
that a trigger is
output after cleaning
-
