Honda EU10iT1, Manual

Page: 79 / 138

8-12
dummyhead dummyhead
GENERATOR/CHARGING SYSTEM
ROTOR INSTALLATION
Clean any oil from the tapered portions of the rotor and
crankshaft.
Check for any foreign material attracted to the inside of
the rotor before installation.
Install the rotor [1] by aligning the key slot with the
woodruff key on the crankshaft.
Hold the rotor with a commercially available strap
wrench [2].
Apply a light coat of engine oil to the threads and
seating surface of the rotor nut (10 mm) [3], and tighten
it to the specified torque.
Install the cooling fan [1] and cooling fan boss [2], and
tighten the two bolts (6 x 16 mm) [3].
Align the locking tab of the starter pulley [1] with the
groove in the cooling fan boss [2], and install the pulley.
Install the washer (6 mm) [1] and bolt (6 x 16 mm) [2].
Remove the strap wrench [3].
TORQUE: 27.5 N·m (2.8 kgf·m, 20 lbf·ft)
[1]
[2]
[3]
[1]
[2]
[3]
[1]
[2]
[1]/[2]
[3]