Honda EU10iT1, Manual

Page: 119 / 138

15-4
dummyhead dummyhead
CYLINDER BLOCK
OIL CASE INSTALLATION
Clean the mating surfaces of the oil case and cylinder
block [1] with a degreasing detergent or a clean shop
towel.
Install the two dowel pin (6 x 15 mm) into the cylinder
block (page 15-3).
Apply a bead
Φ 1.5 – 2.0 mm ( Φ 0.06 – 0.08 in) of liquid
sealant (Threebond ® 1207B or equivalent) to the mating
surface of the cylinder block as shown.
Install the oil case on the cylinder block (page 15-3).
• Assemble the oil case within 3 minutes after
application of the liquid sealant.
• If it is hard to install the oil case, install by turning the
crankshaft a little.
• Take care not to damage the oil seal lip.
Install the bolts and tighten them to the specified torque
in the numbered sequence.
• Wait for 20 minutes after assembly. Do not add oil or
start the engine during this period.
BREATHER VALVE INSTALLATION
Clean the breather valve [1], stopper plate [2] and the
valve installation section of the cylinder block.
Install the valve by aligning the projections [3] and
chamfered corner [4] with the grooves and chamfer of
the cylinder block.
Install the stopper plate by aligning the chamfered
corner with the chamfer of the cylinder block.
Tighten the screw (3 mm) [5] securely.
[1]
TORQUE: 7.3 N·m (0.74 kgf·m, 5.4 lbf·ft)
1
2
3
4
5
6
8
7
[1] [2] [3] [5]
[4] [3]