Honda EU10iT1, Manual

Page: 51 / 138

5-4
dummyhead dummyhead
COVER
INSTALLATION
Before installing, check the wire and tube routing in the
L. side cover (page 2-8).
Connect the 2P connector and bind it with the
cable tie.
Connect the fuel tube to the fuel tank.
Connect the fuel tube and diaphragm tube to the fuel
pump.
Set the engine unit on the L. side cover, and check the
following:
• L. tank mounting rubber [1] is set in the groove and
over the bosses [2] of the L. side cover.
• Inverter mounting rubber [3] aligns with the set part
[4] of the L. side cover.
• L. side cover is set in the groove in the neck seal [5].
• Set the engine bed insulator and shroud insulator in
the designated position of the L. side cover. Take
care not to allow the washers to come off.
Install the two insulator the collars A [6] and insulator
collar B [7] securely.
Check to see whether the cover seal A [1] and cover
seal B [2] are securely set in the groove in the R. side
cover.
Install the R. side cover on the L. side cover, and check
the following:
• R. tank mounting rubber [3] is set in the groove and
over the bosses [4] of the L. side cover.
• R. side cover is set in the groove in the neck seal.
• R. side cover is securely set in the groove in the L.
side cover.
Install the following:
– Two washers (6 mm) and screws (6 x 100 mm)
(page 5-3)
– Two screws (6 x 20 mm) (page 5-3)
– Circlip (10 mm) (page 5-3)
– Four rubber feet and screws (6 x 10 mm) (page 5-3)
– Screw (5 x 10 mm) (page 5-3)
– Control panel (page 8-6)
– Muffler protector (page 5-2)
– Maintenance cover (page 5-2)
[1]
[2]
[3]
[5]
[4]
[7]
[6]
[1]
[2]
[4]
[3]