Honda EU10iT1, Manual

Page: 121 / 138

15-6
dummyhead dummyhead
CYLINDER BLOCK
VALVE/VALVE SPRING REMOVAL/INSTALLATION
Remove the oil case/crankshaft/piston/connecting rod assembly (page 15-3).
INSTALLATION:
Remove carbon deposits before installation.
Check the valve head for damage.
Do not interchange with the exhaust valve.
The intake valve is larger than the exhaust valve.
INSTALLATION:
Remove carbon deposits before installation.
Check the valve head for damage.
Do not interchange with the intake valve.
The exhaust valve is smaller than the intake valve.
VALVE STEM SEAL
(IN side only)
EXHAUST VALVE
REMOVAL:
Push down and slide the valve spring
retainer [1] to the side so that the valve
stem [2] slips through the hole at the
side of the valve spring retainer.
INSTALLATION:
Install the valve spring retainer while
holding the valve with the handle of the
a driver or hammer.
VALVE SPRING RETAINER (2)
VALVE SPRING (2)
(Entire surface)
(Valve stem sliding surface and stem end)
(Valve stem sliding surface
and stem end)
[1]
[2]
INTAKE VALVE