Honda EU10iT1, Manual

Page: 71 / 138

8-4
dummyhead dummyhead
GENERATOR/CHARGING SYSTEM
From page 8-3
Start the engine and check the overload indicator
light (red) ON. Disconnect the load, and restart the engine and
recheck the AC output.
OFF
ON
Stop the engine and check the AC receptacle
(page 8-8). Replace the AC receptacle (page 8-7).
Normal
Abnormal
No voltage
Remove the stator (page 8-10).
Check the harness between the inverter unit and
stator for an open or short circuit.
If it is normal, replace the stator.
Low voltage
Normal
Normal
Replace the inverter unit (page 8-9).
Pull the recoil starter and measure the sub
winding AC voltage.
Terminal number: 4 – 5
Voltage: 1.0 – 2.0 VAC
Low voltage
Replace the rotor (page 8-10).
W
Bu
R
Remove the control panel (page 8-6).
Disconnect the generator 5P connector from the
inverter unit
Pull the recoil starter and measure the main
winding AC voltage.
Terminal number: 1 – 2 Voltage: 10 – 30 VAC
Terminal number: 1 – 3 Voltage: 10 – 30 VAC
Terminal number: 2 – 3 Voltage: 10 – 30 VAC