Honda EU10iT1, Manual

Page: 49 / 138

5-2
dummyhead dummyhead
COVER
COVER
MAINTENANCE COVER REMOVAL/
INSTALLATION
Loosen the screw [1] and remove the maintenance
cover [2].
To install the maintenance cover, set it on the L. side
cover by aligning the tabs with the holes.
Tighten the maintenance cover screw to the specified
torque.
FRONT COVER REMOVAL/
INSTALLATION
Remove the four screw [1] and front cover [2].
Installation is in the reverse order of removal.
MUFFLER PROTECTOR REMOVAL/
INSTALLATION
Remove the following:
– Four screws (5×16 mm) [1]
– Muffler protector [2]
– Rubber seal [3]
Installation is in the reverse order of removal.
• Be sure that the rubber seal is set on the protector
securely.
• Set the rubber seal on the protector by aligning the
projection [4] with the groove [5] as shown.
TORQUE: 2.3 N·m (0.23 kgf·m, 1.7 lbf·ft)
[1]
[2]
TORQUE:
FRONT COVER SCREW:
2.3 N·m (0.23 kgf·m, 1.7 lbf·ft)
[1]
[2]
TORQUE:
MUFFLER PROTECTOR SCREW:
2.3 N·m (0.23 kgf·m, 1.7 lbf·ft)
[1]
[2]
[4]
[3]
[5]