MAINTENANCE
7-54
Check Hydraulic Oil Level --- daily
IMPORTANT: Never run the engine without oil in hy-
draulic oil tank.
1. Park the machine on a level surface.
2. Position the machine with the front attachment posi-
tioned as illustrated on the right.
3. Lower the bucket to the ground.
4. Turn the auto-idle switch off.
IMPORTANT: The turbocharger may be damaged if the
engine is not properly shut down.
5. Run the engine at slow idle speed without load for
five minutes.
6. Stop the engine. Remove the key from the key
switch.
7. Pull the pilot control shut-off lever to the LOCK posi-
tion.
8. Check oil level gauge (1) on hydraulic oil tank. Oil
must be between marks on the gauge (1). If neces-
sary, add oil.
WARNING: Keep body and face away from cap
(3). Turn cap (3) slowly and remove the cap only
after releasing the internal pressure completely.
To add oil:
9. Insert the wrench as shown and turn the wrench
clockwise and hold the wrench.
10. Turn cap (2) counterclockwise about 30
°
, at which
point stop cap (2) to release the air.
11. Turn cap (2) further and remove cap (2).
12. Align the projected part of cap (2) with the projected
part of the case and install cap (2).
13. Add oil. Recheck oil level gauge (1).
14. Install cap (2).
NOTE: Always allow oil to settle before checking the
level. This may require 15 minutes.
NOTE: Oil can be refilled from the ground using the
Fast-Filling panel located in the rear of the base
machine. Refer to page 1-38 for the Fast-Filling
panel operation.
M142-07-093
M117-07-127
M146-07-034
M110-07-022
1
Wrench 4 mm
Side Hole
Projection
Case Assembly
Projection
Arrow
2
Summary of Contents for EX 3600-6
